Tkool Electronics

push({});Where We Can Use How to Use BC5401 Transistor:As descried above this is a high voltage transistor therefore it can be used in any type of high voltage application in which the load is consuming less current.

DS80PCI800

push({});Where We Can Use How to Use BC5401 Transistor:As descried above this is a high voltage transistor therefore it can be used in any type of high voltage application in which the load is consuming less current.

The collector dissipation is 12.and BD379BD139 Transistor Explained / Description:BD139 is a popular NPN transistor used in wide variety of electronic circuits.

DS80PCI800

arduino projects and other microcontroller projects5A or 1500mA and use a suitable heat sink with the transistorpush({});Where We Can Use it How to Use:BC337 can be used in variety of electronic circuits and projects.

DS80PCI800

The maximum temperature in which this transistor can survive is from -55 to +150 centigrade so do not expose it in the temperature below -55 centigrade and above +150 centigrade.This little TO-92 transistor is packed with lot of good features which makes it suitable for used in many electronic circuits.

DS80PCI800

2N2222BC337 Transistor Explained / Description:BC337 is a NPN transistor with good characteristics.

BC337 is another good transistor that is having many good features in its small TO-92 package.push({});Features / Technical Specifications:Package Type: TO-92Transistor Type: NPN DarlingtonMax Collector Current(IC): 500mAMax Collector-Emitter Voltage (VCE): 30VMax Collector-Base Voltage (VCB): 30VMax Emitter-Base Voltage (VEBO): 10VMax Collector Dissipation (Pc): 625 miliWattMax Transition Frequency (fT): 125 MHzMinimum Maximum DC Current Gain (hFE): 5000Max Storage Operating temperature Should Be: -55 to +150 CentigradePNP Complementary:PNP Complementary of MPSA13 is MPSA63Replacement and Equivalent:MPSA14.

It can be used as an audio amplifier.2N7051 (Pin configuration of the replacement or substitute transistors mentioned here may different from the MPSA13 therefore it is suggested to check pin configurations before replacing in a circuit.

5A that is quite enough to drive variety of loads.It has a DC current gain of 5000 due to which the collector and emitter will be saturated on very small amount of current and the maximum collector-emitter saturation voltage is only 1

访客,请您发表评论:

Powered By Tkool Electronics

Copyright Your WebSite.sitemap